CO₂ Controller digital is an easy-to-use controller, for measure and maintain CO₂ levels in your greenhouse or growing room: a large digital LCD screen where you can read ppm levels, day, hour, minutes, alarms, etc. in real time. This screen is divided into areas that make it much easier and faster to locate the reading of the parameters.
- Center: you can mark the CO₂ levels you want in the room
- Zone: hysteresis or dead band
It has an external probe (ppm), with a 4.5 meter cable, and a photocell to activate the controller during the day, since it is not necessary at night. It has a fuse that protects the controller. Calibrate the controller easily and quickly, just by pressing the enabled button on the probe for 3 seconds, placing it outside so that it starts from 400-450 ppm. After 15 minutes you will have the controller ready.
You can change the probes, to have the controller as precise as the first day.
FUNCTIONS
- Easy calibration with the built-in probe
- Min/max (weekly)
- Real-time parameter display
- Automatic calibration
- Increase/reduce CO₂
- Light detector sensor (photo-cell): day/night
- Programmable desired CO₂ levels
- Programmable alarm
This controller can be used in two modes: plant mode and person mode
Digital CO₂ Controller | Features |
Measurement range | 0 to 9999 ppm |
Resolution | 1 ppm (0-1000), 5 ppm (1000-2000) 10 ppm (>2000) < /td> |
Precision | 5% (<3000 ppm), 7% (>3000 ppm) |
LCD screen | 73 x 100 mm |
Switchboard dimensions (cm) | 15.6 x 11.6 x 3.9 cm |
Sensor dimensions | 11.7 x 3.5 x 2.7 cm |
Working conditions | 0 to 50 ºC / 5 to 95% RH |
Weight | 750 g |