Eventually, every growing method will develop fertilizer residues as a natural part of the process. The buildup of these residues leads to salt accumulation, which can clog drippers and cause unsightly deposits on soil or growing media. Ultimately, your plants will have to make unnecessary effort, and the roots may even be damaged.
With the highly concentrated nutrients available on the market today and the high electrical conductivity levels used in many systems, nutrient lockout can also appear as an invisible limit on your crops. FlashClean® solves all these problems and more:
-
Dissolves accumulated fertilizer salts
-
Corrects nutrient balance
-
Treats nutrient lockout
-
Promotes microbial life and refreshes soil and coco coir
-
Maximizes growth during the final stage (especially with FinalPart®)
Specifically developed to dissolve mineral salts, FlashClean® breaks the nutrient bonds between minerals and the growing medium, allowing excess residues to be flushed away. This process also helps plants make the most of any remaining fertilizers, especially during the crucial final week before harvest.
Unlike other flushing and end-of-cycle products available on the market, FlashClean® is not an acid, is not enzyme-based, and does not introduce magnesium or other mineral additives into your system, making it exceptionally flexible. With FlashClean®, you can give your system and your plants a fresh start at any time and at any stage of the growing process.
Regardless of the type of growing system you are using — indoor or outdoor, hydroponic, in pots, or in garden beds — FlashClean® is easy to use: simply mix it with pH-adjusted water and apply.
FLASHCLEAN®, Terra Aquatica
Do you have any questions?
Where to buy?
INSTRUCTIONS FOR USE:
In recirculating hydroponic systems:
To reset and refresh before changing nutrients (including before FinalPart®): add 1.5 to 3 ml/L of FlashClean® to your existing nutrient solution and let it circulate for 24 hours before draining and replacing it with a fresh nutrient solution. Use the lower dosage for younger or more fragile plants and the higher dosage for well-established plants or those close to harvest.
After nutrient burn or lockout: Drain the old nutrient solution and add 1.5 to 3 ml/L of FlashClean® to pH-adjusted water (a full tank is not necessary — only enough for proper circulation and system operation). Let it circulate for 24 hours before draining and adding a fresh nutrient solution. Use the lower dosage for younger or more fragile plants and the higher dosage for established plants.
As a final rinse (after FinalPart®): Drain the old nutrient solution and add 1.5 to 3 ml/L of FlashClean® to pH-adjusted water (a full tank is not necessary — only enough for proper circulation and system operation). Let it circulate during the final two days before harvest to increase sugar levels in your crop while avoiding loss of aroma and medicinal content from excessive water flushing.
In soil pots and soilless mixes, including coco coir:
To reset and refresh before changing nutrients (including before FinalPart®) and after nutrient burn or lockout: every 15 days (or whenever necessary after lockout, etc.), fill a watering can with fresh pH-adjusted water and add 1.5 to 3 ml/L of FlashClean®. Soak the medium until water drains from the bottom of the pot. Resume your regular feeding schedule at the next watering. Use the lower dosage for younger or more fragile plants and the higher dosage for established plants.
As a final rinse / after FinalPart®: use 3 ml/L of FlashClean® instead of nutrients during the last two days before harvest to increase sugar levels in your crop while avoiding loss of aroma and medicinal content from excessive water flushing.
Note: FlashClean® can be used at any stage of growth or flowering, but do not use FlashClean® more than once every two weeks.
